Litter-Robot 4 Automatic Litter Box - Quick Start Guide

Ensure Proper Placement
Power On
Add Lier
1
3
2
4
If possible, place the Lier-Robot in the same location
as the old lier box (at least during transition).
Make sure the unit is indoors on a rm, level suace and in a
cool, dry location. Must not be touching any walls.
Place lier mats or rugs in front of the unit.
The Lier-Robot will now peorm an initial clean cycle.
Need help? Visit whiskersuppo.com
Use clumping lier or lier beads and crystals that are small
enough to pass through the screen.
Add lier until it meets the raised MAX ll line when spread
flat (8-10 lbs or 3.6-4.5 kg). Be careful not to oveill.
Download the Whisker app
and follow the onboarding
instructions.
Lier Fill Line
Plug the small end of
the power supply into
the power input on the
back of the base.
Plug the AC/DC
adapter into a wall
outlet.
Press the Power
buon on the control
panel.
Download The App
Power
Press the Power buon to turn
the robot ON or OFF.
The robot will begin a clean cycle
when power is turned on.
Connect
Press the Connect buon to turn the
WiFi ON or OFF.
A long press, while at the home position,
will initiate the onboarding process.
Cycle
Press the Cycle buon to sta a
clean cycle.
If already cycling, press Cycle to
pause; press again to resume a cycle.
A long press, while at the home
position, will enter sleep mode.
Reset
Press the Reset buon to zero the
weight scale.
A long press, while at the home position,
will enter night light seing mode.
If already cycling, press Reset to pause
a cycle; press again to cancel a cycle.
If already cycling, a long press will
reset the cat sensor weight scale.
Empty
Press the Empty buon to sta
an empty cycle.
If already cycling, press Empty
to pause.
A long press, while at the home
position, will enter wait time
seing mode.
Control
panel
icons
Note: During initial clean cycle, the cat sensor weight scale is
disabled to ensure proper calibration.