System information

Message

: Total maximal duration of delays exceeded in the unit #_.

Explanation

: The number of delay blocks, and their combined delay ranges,

exceeds the maximum capability of this unit. Currently, any single

E Desk unit can provide a maximum of 45 seconds of delay blocks.

Matrix Mixers with Delay also contribute to this total, consuming

1 second per input channel.

Allocation of DSP blocks to DSPs

Message

: Allocating blocks to DSPs...failed to set up a feasible DSP task

schedule in the unit #__. You should move some processing blocks

from this unit into another unit using fixed allocations.

Explanation

: Although the total DSP power in the E Desk unit is sufficient, compile

was not able to distribute the component objects among the

available DSPs. When the DSP load approaches 100%, it becomes

crucial that the objects be distributed more uniformly. Try moving

certain objects to another unit (using fixed allocations), or replace

them with a comparable set of smaller objects (within the same unit).

Otherwise, it may be necessary to add an additional E Desk unit to the

system, and move large DSP blocks into it using fixed allocations.

Assigning control blocks to E Desk units

Message

: Some unconnected control blocks have been ignored.

Explanation

: Control blocks with no connections have been excluded from the

system. Only Logic Gate , Logic Delay, and Remote Preset Button

blocks can be ignored. When connected to the system, control dialogs

for ignored blocks cannot be accessed.

Message

: Feedback detected in the control network.

Explanation

: The potential exists for a control path to be indirectly looped back

upon itself. This condition could be dangerous, and is not allowed.

Message

: Unit #__ has too many control connections.

Explanation

: Although quite large, there is a limit to the quantity of control

connections within a single unit. Connections include both internal

(source and destination within same unit) and external links (source

or destination within this unit). Try moving certain control objects to

another unit (using fixed allocations),