System information

91
Message
: Insufficient computing power to implement this layout.
Explanation
: The design requires more DSP resources than are available
from the E Desk device(s) specified in the Equipment Table. This
can only occur if the flag 'Auto Device Add' is not set under
Tools>Options>Compile.
Message
: Feedback loop detected.
Explanation
: The potential exists for an audio path to be indirectly looped back
upon itself. This condition could be dangerous, and is not allowed.
Messages
: Specified E Desk unit #__ is not in the Equipment Table.
Specified E Desk unit #__ is not selected for use.
Explanation
: Some DSP blocks have been assigned as fixed allocations in a
specific E Desk unit which is not available or selected for use.
Messages
: Too many audio inputs required for fixed allocations in unit #__.
Too many audio outputs required for fixed allocations in unit #__.
Unit #__ has no CobraNet communication module.
Too many CobraNet inputs or outputs allocated to unit #__.
Explanation
: The number of audio channels assigned as fixed allocations in a
specific E Desk unit exceeds the capacity of that unit.
Messages
: Insufficient DSP power for fixed allocations in unit #__: ___% of
capacity requested.
Explanation
: The DSP resources assigned as fixed allocations in a specific
E Desk unit exceed the capacity of that unit.
Message
: Gang #__ requires too many resources.
Explanation
: The component objects allocated to the specified gang require more
resources (audio channels, CobraNet channels, and/or DSP power)
than is available from any current E Desk unit.
Messages
: DSP tasks for fixed allocations in unit #__ cannot be scheduled.
DSP tasks for gang #__ cannot be scheduled.
Explanation
: Either fixing the allocations or ganging the DSP blocks dictates that the
DSP blocks be located in the same Audia unit. However, in this case
it is not possible to distribute the DSP blocks among the available
DSPs in that unit. See also 'Allocation of DSP blocks to DSPs' below.