System information

77
Control Labels
The V8, S8, and VS8 controls all come with a sheet of clear, adhesive-backed labels, for custom printing on
a laser printer. A Word document (V8S8 B Labels.doc) is available on the E Desk software CD and on the
Whirlwind web site (www.whirlwindusa.com), as a label printing template. These labels are meant to be
printed using desk-top laser printers only. It is recommended that the printer be set for 'label' printing, and
the label sheet should be 'short-edge' feed from the 'bypass' tray. A test printing of a single label should be
done, to assure proper alignment of text. To compensate for any mis-alignment of text, margins within the
Word document may be adjusted. Care should be taken in placement of the labels onto the controls. To
avoid finger-prints, the use of a knife-blade or tweezers is recommended for handling. Severe bending or
curling of the label may cause loss of some toner (text). When placing the label on the control panel, use
the vertical column of LED indicators as a visual reference of alignment. Once the label is in place, a
second (un-printed) label may be placed over the first label, to provide protection against wear. Each sheet
contains 25 labels, so in case of errors, additional labels may be printed.
In the Word document, select Show Gridlines from the Table menu. Each large cell represents a label. The first four
columns are 'left-justified' to create labels for V8 and S8 panels, as well as for the 'Volume' (left) section of VS8 panels.
The last column is 'right-justified' to create labels for the 'Select' (right) section of VS8 panels. Left-click inside any
large cell, and begin typing. Use 'Enter' to begin a new line, and again to leave a blank line. To avoid printing errors,
do not change line-spacing or other formatting parameters. However, if you do not have the default font (Helvetica), or
if you wish to change label appearance, you may select a different font before typing.