Manual

ManualsBrandsWhirlpool ManualsWashersThin Twin

Ì2IF

■ Appli,

Thin Twin

Washer»Dryer 230 Volt, 50 Hz

' ' lléC

Installation Instructions

IMPORTANT:

Read and save

tnese instructions.

IMPORTANT:

homeowner.

Homeowner; Keep Installation Instructions

for future reference ^^"'->'>5

Save Instaltation Instructions for local

electrical inspector's use

Part No. 3397516

Summary of content (7 pages)

PAGE 1
Thin Twin Washer»Dryer 230 Volt, 50 HzlléC ' ' Ì2IF Installation Instructions ■ Appli, IMPORTANT: Read and save tnese instructions. IMPORTANT: homeowner. Homeowner; Keep Installation Instructions for future reference ^^"'->'>5 Save Instaltation Instructions for local electrical inspector's use Part No.
PAGE 2
Before yoti start... Check location where washer/dryer will be installed. Proper installation is your responsibility. The washer/dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Make sure you have everything necessary for correct installation. Important: Observe all governing codes and ordinances. ^WARNING Check code requirements. Some codes limit or do not permit the installation of clothes dryers in garages, closets, mobile homes and sleeping quarters.
PAGE 3
Exhaust requirements ^WARNING Fire Hazard • Do Not use non-metal, flexible duct. • Do Not use metal duct smaller than 4 Inches (10.2 cm) In diameter. • Do Not use exhaust hoods with magnetic latches. • Check that exhaust system Is not longer than specified. Exhaust systems longer than specified will: — Accumulate lint. — Shorten the life of the product. — Reduce performance and result In longer drying times and Increased energy usage. Failure to follow specifications may result In a fire.
PAGE 4
I Insert a rear leveling leg into the hole in the rear corner on the bottom ot the washer/dryer. Push leg in until It snaps into place. Do the same same thing with the other leveling leg in the other rear corner. Numbers correspond to steps. 9. I Push up one leg; check to see that the other leg goes down. Check the other leg the same way. (If legs do not adjust, repeat Step 4.) ^5 ■ With one of the front legs in hand, check the ridges for a diamond marking.
PAGE 5
Numbers correspond to steps. IMPORTANT: THIS PROCEDURE MUST BE FOLLOWED TO ASSURE PROPER INSTALLATION. 1/4" ■(.64 cm) max. clamp drain hose 1/4" 64 cm) max. I To prevent the drain hose from coming off or ieaking, if must be installed per the following instructions: 1. Wet the inside end of the drain hose with tap water. DO NOT USE ANY OTHER LUBRICANT. 2. Squeeze ears of small clamp with pliers to open clamp and place clamp over end of drain hose. 3.
PAGE 6
Closet installation I Determine the length of exhaust duct that is needed to connect the dryer to the exhaust hood. See "Exhaust requirements," Panei B. 26 I Remove tape from dryer door and open dryer door. Remove tape across the dryer lint screen. Check to be sure lint screen is in its proper position. Wipe out drum with a damp cloth to remove any dust. Start dryer and allow it to complete a heat cycle to make sure the dryer is working properly.
PAGE 7
If washer/dryer does not operate... If you need assistance... When moving the washer/dryer... • Check that the circuit breaker is not tripped or the house fuse blown. • Check that power supply cord is piugged into wall receptacle. • Check that washer lid or dryer door is ciosed. • Check that controls are set in a running or "ON" position. • Check that dryer "START" button has been firmly pushed. Call your dealer or local authorized service company.