Operating instructions

Porcher, 6615 West Boston Street, Chandler, AZ 85226 5
REPLACEMENT USE
When replacing an original bath, ensure to shut off the water supply and disconnect electrical power
before removing. Disconnect water supply lines and drain fittings. Original supplies and fittings should be
replaced on installation.
INSTALLATION PROCEDURES
Typical installation includes electrical power connection. Installation of house drain, floor riser, hot and
cold water supply lines, shutoff vales, and fittings. Installations may require wall preparation or support
framing.
INSTALLATION OF DRAIN MUST BE PERFORMED BEFORE BATH IS PLACED
INTO INSTALLED POSITION.
ALL INSTALLATION PROCEDURES MUST COMPLY IN STRICT ACCORDANCE
WITH APPLICABLE LOCAL PLUMBING AND BUILDING CODES
ELECTRICAL MUST COMPLY WITH THE NATIONAL ELECTRICAL CODE
FRAMING SUPPORT PREPERATION
Baths can be installed either above or below floor line as pier or recess type. Sump of bath is supported by
integral feet, no additional support required.
Important Note:
Ensure in all installations to provide provisions for an access opening for servicing pump and controls
unless an access opening of at least 12” x 24” (30.5cm x 61cm) is provided, warranty service will not be
performed.
STEP 1. Determine type and location of installation and ensure that you have the proper room for the
specified dimensions. Ensure to include proper room for the access opening.
STEP 2. Construct support framing.
Pier Installation Note
For pier type installation construct framing ensuring proper dimensions as specified. See diagram on next
page.
Recess Installation Note
For recess type installation locate studs and ensure proper dimensions and that studs are plumb and
square. Attach leveling stringers and cutout to studs at the height indicated. See diagram on next page.