Operating instructions

Porcher, 6615 West Boston Street, Chandler, AZ 85226 3
HEATER OPERATING PROCEDURES
The heater once installed is totally automatic. The heater will maintain the temperature of the water in the
bath, or increase the temperature at about two to four degrees Fahrenheit per hour.
THERMOSTAT
The thermostat requires no adjustment and will automatically maintain the water temperature at 104
degrees Fahrenheit. If bath water is to warm, simply adjust by adding cold water.
HIGH LIMIT
The heater includes an exclusive “Intelligent High Limit”; this safety circuit will not “false-trip” from hot
tap water. It will only turn the heater off if the thermostat fails. To re-set, simply press the RED re-set
button. If the high-limit “trips” frequently, call a service person.
INDICATOR LIGHT
The heater indicator light turns on when heater is operating.
PRESSURE SWITCH
The heater is equipped with a pre-set pressure switch. This switch will not allow the heater to turn on if
the pump is not running with water flowing in the whirlpool.
TOOLS AND MATERIALS REQUIRED
Most of the procedures require the use of common tools and materials, which are available from hardware
and plumbing, supply stores. It is essential that the tools and materials be on hand before work is begun.