Operating instructions

Porcher, 6615 West Boston Street, Chandler, AZ 85226 2
IMPORTANT SAFETY PRECAUTIONS
NO UNATTENDED CHILDREN
To reduce the risk of injury, do not permit children to use the bath unless they are closely supervised at all
times.
NO SMALL OBJECTS
Keep small objects away from the whirlpool. Never drop or insert any object into any opening. Objects
may be drawn into the circulation system and cause system to malfunction. Do not operate this bath
without the guard over the suction fitting. Do not use attachments not recommended by the manufacturer.
NO SOAP OR OILS
Do not operate the whirlpool circulation system when using soap, bath oil, or bubble bath, or if such
substances are in solution in the bathwater. If introduced into the circulation system the substances are
likely to cause excessive foaming. Bathe with soap or oil only when whirlpool circulation system is OFF.
Drain whirlpool after each use.
NO FOOD OR ALCOHOLIC BEVERAGES
Avoid using whirlpool immediately after meals. Avoid alcohol consumption before bathing. Alcoholic
beverages can cause drowsiness resulting in loss of consciousness or even drowning. The same
precautions apply to certain medications.
PREGNANCY
Consult your physician before using to obtain advice on water temperature and immersion time.
WHIRLPOOL OPERATING PROCEDURES
AIR SWITCH
The air switch push button is mounted on the deck of the tub. To start whirlpool push on center of button,
button will depress and whirlpool will start. To stop whirlpool depress button again and release and
whirlpool will stop.
Important Note:
Always fill the whirlpool before operating the pump. “Dry running” the system will cause pump damage
and void the pump warranty. Water level must be at least one inch (25mm) above all inlet jets.
AIR VOLUME CONTROL
Water turbulence is determined by the amount of air mixed with the water. Rotate the air volume control
counterclockwise for more turbulence, clockwise for less.
JET ADJUSTMENTS
The direction of water flow can be adjusted manually by moving the jet to the desired position. The
amount of water flow may be adjusted from vigorous to soft by rotating the nozzle. Rotate nozzle
clockwise for vigorous flow and counterclockwise for soft flow. You may need to balance the air volume
control and the water flow for the most desirable condition