Specifications

13
Figure 13
LID AND SPIN TEST
1. Make sure the washer lid is closed before starting test.
2. Press “SELECT” pad under Temperature four times to turn off all water valves. (NOTE: Display
will show “Small” indicator light.)
Lid Switch Test
1. Press the “SELECT” pad under TIME unitl the “4” indicator LED is lit. the washer should start to
spin.
2. If the washer is not spinning, open and close the lid to reset the Neutral Drain Mechanism. If the
washer is still not spinning go to step 4.
3. If the washer is spinning, the lid switch is functioning correctly. Continue to Low Speed Spin
Test.
4. If the washer is not spinning:
a. Unplug the washer from household power supply.
b. Open the console and disconnect the lid switch connector on the cabinet.
c. Measure continuity between the outside pins on the 3-pin
connector socket with an ohm meter.
(Fig. 13)
d. Verify that, with the lid closed, the switch is closed (0 ohms)
e. Verify that, with the lid open, the switch is open (~ ohms)
f. If either conditions in d. or e. are not true, replace the lid
switch. Continue to Low Speed Spin Test.
Low Speed Spin Test
This test should be conducted with the lid switch closed.
1. Press the “SELECT” pad under TIME until the 4 indicator LED is lit. the washer should start to
spin.
2. Low speed spin is functioning properly if the washer is spinning. Go to Medium Speed Spin Test.
3. If washer is not spinning:
a. Unplug washer from 120VAC household power supply.
b. Open the console and inspect for loose connections. Disconnect and reconnect all wires
from the electronic control assembly.
c. Close the console, plug the washer into the household power supply and repeat steps 1 & 2.