Technical data

ManualsBrandsWhirlpool ManualsCooktopKR-32

Z1209004. 5 GB

Enjoy the RIHO life-style

Whirlpool Electronic LCD user handbook

5.0 Whirlpool Jets

5.1 Aero jet

The aero jet has a chrome surface finish. To clean the jet, the inner part can be taken out with a small

screwdriver.

As the word Aero already indicates, this is a jet for air flow. The air swirls through the water, which gives a

relaxing effect. The air from the aero jet opening enters the bath with a certain speed. This may be

perceived as cold. The jet house itself becomes somewhat hot.

BE AWARE: Be very careful not to damage the chrome surface.

After cleaning the jet house, the inner part can be pushed back. The inner part is clamped by an O-ring.

5.2 Hydro jets

Hydro jets have a mixed flow of water and air. This results in a powerful ray with a massaging effect. The

RIHO whirlpools and thermae whirlpools are equipped with different types of hydro jets. The type of jets

depends on the choice of the system. The functioning of all hydro jets will be described below.

ATTENTION: Because some type of jets can be closed by turning, it is possible to close the jets while the

motor is running. Don't do this and make sure at least one closable jet is open at all times. Otherwise the

motor can get overheated because of too much pressure. Lisa, Lisette and Dana have two separate

controlled systems. The remark is valid for both systems.

5.2.1 Hydro back- and side jet

Hydro jets have a complete chrome surface finish. The flow can be set, by pointing the opening in the

middle of the jet in the desired direction. This movement is quite heavy. Otherwise the opening would

easily turn back in its straight position, as a result of the water- and air pressure. The back and the sides

of the whirlpool have the same type of jets. The jets in the back are smaller than the ones on the side.

5.2.2 Hydro Super jet

The Hydro Super jet has a complete chrome surface finish. The flow through the jet can be directed

stronger or softer. By turning the inner part of the jet by hand the flow can be adjusted. When the inner

part is turned clock wise, the flow will be less heavy.

5.2.3 Thermae Powerpool rotation jet

The outer ring of the jet has a chrome surface finish, the inside of the jet is made of white plastic. This jet

is only used in some whirlpools of Thermae line. By turning the outer ring of the jet the power of the flow

can be determined. The inner part rotates automatically, which results in a massaging effect.

5.2.4 Thermae Powerpool jet

The outer ring of the jet has a chrome surface finish, the inside is made of white plastic. This jet is only

used in some whirlpools of Thermae line. By turning the outer ring of the jet the power of the flow can be

determined. This jet produces a straight massive ray of water.

Set hydro

Set minijets

Set foot jets

Set backjets

Set aero

Pump-controlled

Switch foot jets on/off (valve function)

Switch back jets on/off (valve function)

Valve controlled jet outputs

Pump-controlled hydro functions

Your whirlpool can be supplied with valve functions in the hydro system or with pump-controlled

outputs. Depending on the system chosen.

Pump-controlled floor functions

Switch minijets on/off (valve function)

Valve control

For each pump the output can be set as constant or pulsing. Depending on requirements the power

per motor can be limited to 70% for pulsation and 50% at constant output.

Set your preference, e.g.

-49--48-

12:10

okok

19°C

12:10

okok

19°C

19°C 12:10

70%

okok

19°C 12:10

okok

70%