Installation guide

ManualsBrandsWhirlpool ManualsRangeOfficial Whirlpool gas range

m m

i Burne

with self-cleaning oven

9758663

Tip Over Hazard

A child or adult can tip the range and

be killed,

Connect anti-tip bracket to rear

range foot.

Reconnect the anti-tip bracket, if the

range is moved.

Failure to follow these instructions can

result in death or serious burns to

children and adutts.

ii i ii ii

Pages

[]

Before you start

EUectdcaUrequirements

Gas suppUyrequirements

Product dimensions

Cabinet dimensions/requirements

installation steps

Gas conversions

if range does not operate

if you need assbtance/service

Moving the range

www.whM pooH.corn

Read and save these instructions.

_MPORTANT:

_nstaHer: Leave Installation

Instructions with the homeowner.

Homeowner: Keep Installation

Instructions for future reference.

Read and save these instructions

for local electrical inspector's use.

Write down the model and serial

numbers before installing range.

Both numbers are listed on the

model/serial rating plate located on the

oven frame behind the storage drawer

panel

Model #

Serial # Part No. 9758663

Summary of content (12 pages)

PAGE 1
m m 9758663 i Burne e with self-cleaning oven \ \ Pages ii Tip Over A child or adult be killed, Connect anti-tip range foot. i ii [] [] [] [] [] ii Hazard can tip the range bracket and Before you start EUectdcaU requirements Gas suppUyrequirements Product dimensions Cabinet dimensions/requirements installation steps to rear Gas conversions Reconnect the anti-tip range is moved.
PAGE 2
Before you start... Your safety and the safety others are very important. of We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word 'DANGER" or 'WARNING.
PAGE 3
Tools needed: Parts supplied: Not shown: • literature pack Materials Assemble the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. level • orifice spuds flat-blade floor-mounted anti-tip bracket Phillips screwdriver valve • 1/2" male pipe thread to pressure regulator • LR gas-resistant nipple pipe-joint for connection compound • AGA or CSA desigmcertified flexible metal appliance connector (4-5 feet) (1.2-1.
PAGE 4
Gas supply requirements Observe aii governing ordinances. codes and This installation must codes and ordinances, conform with local in the absence of connection: local codes, installations with American National National Fuel Gas Code latest edition _. Explosion Hazard Use a new AGA supply mine. or CSA approved mnstall a shutoff vaJve. Securely tighten gas all gas connections. ff connected to LP, have a qualified person make sure gas pressure does not exceed 14" (35.6 cm) water column.
PAGE 5
Product dimensions Grounded electrical oudet is required+ See "Electrical requirements/' Proper gas supply connection must be avaHaNe+ See "Gas supply requirements:" 27-1/8" (68.9 cm) depth with handle 36 _+ (91.4 cm) cooktop height 46-7/8" (!19+1 cm) overall height 25" (63+5 cm) \ 29-7/8" (75+9 cm) width Cabinet dimensions/requirements iMPORTANT: Some cabinet and building materiab are not designed to withstand the heat produced by the oven for baking and self-cleaning.
PAGE 6
New start... Excessive Weight Use two or more instal[ range. people Hazard to move Failure to do so can result other injury. 1[] Contact a qualified floor covering installer for the best procedure for drilling mounting holes through your type floor covering. and in back or Anti-tip securely Do not use oven door handie to Hilt or move the range. m Remove shipping Use the anti-tip bracket to install the anti-tip bracket. materials, and protective film from range.
PAGE 7
Gas and electrical connections m Appiy for use with pipe-joint compound L,R gas to the made smaller Use 5/16" thread ends of the flexibie connector adapters. Attach one adapter to the pressure reguiator eibow and the other adapter to the gas shutoff vaive+Tighten both and channel combination lock pliers wrench to attach the flexible connector to the adapters. that connector is not kinked.
PAGE 8
Check operation Electronic ignition system Cooktop and oven burners use eiectronic ignitors in piace of standing pibts. When a cooktop controi knob is turned to the "UGHT" position, the system creates a spark to Night the burner.This sparking continues until the controi knob is turned to the desired When the setting. oven controi if flame needs to be adjusted, turn control knob to the "LOW" setting and remove control knob. Insert a small flatblade screwdriver into the valve stem.
PAGE 9
[f your oven has electronic If oven flame needs to be adjusted: Locate the air shutter next to the controJs: 1_ Press the "BAKE" pad. • Depending on model, the "BAKE" and "TEMP" indicators will light and "350" will appear in the display or, the "BAKE" indicator will light and "350" vq[[ appear in the display. pressure regulator. Loosen screw and adjust the air shutter until the proper flame appears.Tighten screw.
PAGE 10
GEts convet'sions Gas conversions (from Naturai gas; or from LR gas to Naturai be done by a quaiified installer, gas to LR gas) must f L.R Gas pressure regulator.. Surface burner plastic cover Natural L.R Fire Hazard Shut off gas supply line Make all conversions before gas suppmy valve back on. Failure result to folmow these in explosion, fire turning instructions Natural gas L.R gas can or injury. [] Surface burners: Remove burner caps.
PAGE 11
Reinstall the storage CompJete installation steps drawer, 9 through Checking for proper cooktop oven flame is very important, burner You must adjust cooktop burnec "LOW" setting See Step l& [] Surface 24, and for each burners: Remove caps. Use a Phillips or Quadrex screwdriver to remove the two NOTE: (13 ram} bng,The outer cone is not as distinct as the inner cone.
PAGE 12
If range does not If you need assistance: If you need service: operate: if you have questions cleaning or maintaining Maintain by calling compan% the quality built into your an authorized service To obtain authorized the name and number service company: [_ [_ Check that the circuit tripped or the house Check that plugged the power into the that breaker is not fuse blown. supply cord is [_ Refer to [_ Caii the Customer interaction Center.