Specifications

Install properly.. .
1. Allow ‘/i inch [I 25 cm] space on each side and at
the top of the refrigerator for ease of rnstallation
2. If the refrigerator IS to be agarnst a wall, you might
want to leave extra space so the door can be
opened wider.
3. The refrigerator back can be flush against the wall
Level refrigerator-freezer.. .
Levelting Syq
1
Right to Raise;
Lelt to Lower
1 Remove base grille [see page 7 ),
2 To raise front, turn each screw to the right
3 To lower front, turn each screw to the left.
4. Check with level.
Remove sales labels.. .
Remove ihe Consumer Buy Gurde label, tape and
any inside labels before using the refrigerator.
To remove any remaining glue:
1 Rub briskly with thumb to make a ball then remove.
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removrng glue as descrrbed In step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator
before using it.
See cleaning Instructions
on page 9.
i A
Plug it in...
Plug
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply IS re-
quired It IS recommended that a separate circuit
serving only this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package
4