Specifications

7
IMPORTANT NOTE
2.4. HYGIENIC CLEANING CYCLE
(Only on Whisper Airpool, Whisper Combipool and
Whisper Combipool Plus)
The system bath is equipped with a cleaning system that goes into
operation automatically after the bath has emptied. After the waiting period
of 12 minutes, the cleaning cycle starts and lasts nearly 6 minutes. During
the cycle the system pipes are blown dry. The display of the temperature
indicator will indicate the elapsing of the cleaning time.
The cleaning cycle will also be activated after taking a ’regular’ bath
(without using the system).
Note: The waiting period and the cleaning cycle can be interrupted
and by-passed by touching symbol
on the remote control. The
system then returns to the stand-by mode. Waiting period and
cleaning cycle are also interrupted and by-passed when the water level
again rises (suffi ciently) above the jets. The system can then be put
into operation again.
Manual operation cleaning cycle
The cleaning cycle can also be operated by hand when you have not used
the bath. This can be done by touching symbol once. This could be
desirable if you have showered in the bath or if something else has
caused water to come into the system.
During the cleaning cycle the discharge should be opened. Should you
have started the manual cleaning cycle by accident you can deactivate the
cycle by touching symbol again.
2.5. MAINTENANCE
Little or no dirt at all can lodge on the non-porous surface of the bath, so
that maintenance is limited to wiping it with a wet cloth or sponge. If you
use bath-oil or bath-foam, the bath can be cleaned with a soft soap and
clean water. Never use scouring agents (fi gures 5 and 6)!
NOTE: We recommend rinsing the system once a month with soda, in
particular when you use bath oil. This should be done as follows:
Fill the bath to normal water height. Add approx. 500 grams of soda
dissolved in warm water. Run the system for 10 minutes. Switch off
the system and wait for 10 minutes. Switch the system on again and
run the system for another 10 minutes. Let the water run out of the
bath. Rinse the visible parts (jets, etc.) thoroughly.
2.6. AIR SUPPLY
It must be possible for air to be drawn in suffi ciently for the correct
operation of the system bath by means of a grill or vents. Make sure that
nothing, such as a towel for example, is covering or obstructing the grill or
the vent whilst bathing.
2.7 CLEANING THE DRAIN (not for Whisper Airpool)
System baths are equipped with a specially protective drain cover. If
the openings in the drain cover close up during use, e.g., through dirt or
because you are sitting on it, water circulation is deactivated. In this case
you should switch off the bath for 1 minute and, if necessary, clean the
drain. Then set the bath into operation again.
To remove dirt, the drain cover can be lifted away from the drain hole so
that the upper chamber of the drain can be cleaned (fi gure 7).
5
6