Specifications

3
Installation Notes
1. FITTING
NOTE: A system bath is
installed at a greater height than a
‘normal’ bath due to the addition
of frame and adjustable legs.
1.1 UNPACKING (fi gure 1)
To prevent damage during transport
and installation, the edges of the
system baths are provided with
protective tape before the bath is
enveloped in shrink-rap and packed
in a sturdy cardboard box or wooden
crate.
Unpack the system bath and remove
the tape. Make sure the bath is un damaged before installing it.
1.2 LIFTING
In moving the system bath, it should only be picked up by the edges of
the bath or the frame.
Never lift up the unit by the air pump, by the pump or by the piping
system!
The producer assumes no liability for damage resulting from incorrect
transport or incorrect handling.
1.3 POSITIONING
Remove any unwanted matter from the place where the system bath will
be placed (dust, cement remnants,
etc.) before positioning the bath. This
will prevent damage to the system
which could be caused by sucking up
/ attracting dirt, dust, etc. through the
system parts.
Position the system bath at the place
where it is to be installed. Use a
spirit level to make sure everything is
perfectly horizontal. The spirit level
should be set on the edge of the bath,
not on the bottom! (fi gure 2).
Check that all legs stand fi rmly on
the fl oor. If needed, adjust them.
All electrical equipment, e.g. supply
switch, wiring, etc., should be installed a minimum of 20 mm from the
supporting surface beneath the appliance.
Unit is supplied with approximate 1.8 metres of 3-core electrical fl ex cable
for installation.
NOTE: If your system BATH is supplied with a HEATER then a 15
amp power point is required.
1.4 CONNECTING THE WATER SUPPLY AND DRAIN/OVERFLOW
COMBINATION
Connect the pre-assembled drain/overfl ow combination to the drain
and then check for watertightness. Connection of the water supply and
drainage may only be carried out by a qualifi ed person.
1.5 ELECTRICAL CONNECTION
The installation of electrical equipment and any repairs of such equipment
must only be done by a recognized installer. The electrical installation
and connection must be in accordance with the National Regulatory
requirements.
Connect the system to the mains. As soon as the system is connected, the
display of the temperature indicator will indicate
. The system is ready
for use.
N.B.: If you switch off the power to the system, you should wait
at least 10 seconds before switching the power back on again so as to
prevent malfunctions. This allows the system to re-set.
1. Means for disconnection must be incorporated in the fi xed wiring in
accordance with the wiring rules, via three pin plug set.
1.6 EARTHING FACILITY
On the system’s frame there is a connection for the potential bonding.
This and all metal components which are not part of the system must
be connected to the equipotential bonding that must be present in the
1
2