Setup guide

LC3000 LAUNDRY READER DEFAULT CONFIGURATION SETTINGS
PRINTED OCTOBER 6, 2009
1-40
LC3000 LAUNDRY READER DEFAULT CONFIGURATION SETTINGS
The LC3000 Laundry Reader’s default settings are:
• DHCP enabled
• NP (host) IP address assigned by DHCP server
Restore Default Settings
Forget your password? Restore Default Settings.
1 Connect a cable from a computer’s serial port to the one labelled “RS-232 CONFIG”.
Cable connections are shown in RS-232 Config Port Connections (Page: 11) (Page 8).
2 Open a terminal program (such as Hyperterminal), and then establish connection settings:
9600 baud
1 stop
no parity
no flow control
3 Type xxx within 3 seconds after “Config Task Started” is displayed in the terminal program.
“Restoring to Factory Defaults will display during reset.
4 Disconnect cable from RS-232 CONFIG.