Setup guide

LC3000 LAUNDRY READER INSTALLATION GUIDE
D OCUMENT 1135 REV 03
PRINTED OCTOBER 6, 2009 1-29
When installing the LWI3020 onto a stacked machine, the P2 connector must be installed into
the control board of the even numbered machine. For example, if the stacked machine will be
assigned machines 3 and 4 within the laundry center, then the P1 connector would be installed
in the control board identified as machine 3 and the P2 connector must be installed in the
control board of the machine identified as machine 4.
3 Install the two Molex pins connected to the Orange and Blue wires on the wiring harness into the two
open positions of the transformer’s secondary output connector.
This is an AC output, so the pins are interchangeable.
4 Install the 22-pin connector of the wiring harness onto the LWI3020 wireless module.
5 Mount the wireless module inside the console compartment using the double-sticky tape provided, or
install the module on the outside of the machine using the sheet metal screws.
If installing inside the hood compartment, keep the module away from the control board and
any potential electrical interferences.
6 Use the wire ties and wire tie blocks included with the LWI3020 to dress the wires within the
compartment.
7 Re-install the operator console on the machine.
Figure 1-24 LWI3020 installation in Speed Queen/Alliance laundry
machine
former
LWI
wireless mo
“Even Numbered Machine” for stacked machine only
Red
Red
Controller
Board
(Odd or only)
Controller
Board
(Even)
wires indicates
al secondary output