Setup guide

LC3000 LAUNDRY READER INSTALLATION GUIDE
D OCUMENT 1135 REV 03
PRINTED OCTOBER 6, 2009 1-27
INSTALL THE LWI3010 MODULE FOR
MAYTAG LAUNDRY MACHINES
Maytag laundry machines require an LWI3010 module. A
single LWI3010 will support both single washer/dryer
machines and stacked dryer machines.
Disconnect all power to the machines.
1 Remove the operator console (with display and switches) from the machine.
Single machine: remove only the top two screws.
Stacked machine: remove only the lower two screws on the top panel.
2 With access to the machine’s control board, Install the six-pin connector of the wiring harness into the
(AA3) connector of the laundry machine’s control board.
Stacked machines: Install the 2-pin connector on the wiring harness into the (AA2) connector of the
control board.
3 Install the 22-pin connector of the wiring harness into the LWI3010 wireless module.
4 Mount the wireless module inside the hood compartment using the double-sticky tape provided, or
install the module on the outside of the machine using the sheet metal screws.
If installing inside the hood compartment, keep the module away from the control board and
any potential electrical interference sources.
5 Use the wire ties and wire tie blocks included with the LWI3010 to dress the wires within the
compartment.
6 Re-install the operator console on the machine.
Figure 1-22 LWI wireless module
Status LED
Transmit LED
Error LED