Specifications

7
FireLite Furnace Operations Manual
After approximately one minute, the display will revert from
the item being displayed to the time remaining if a program
is running or to muffle temperature if the furnace is in
idle mode.
Program and Vacuum Status LED Graphs
• Indicatestheitembeingenteredwhileenteringa
program.
• Indicatesthestatusofaprogramwhilerunning.
Start Program Button
Pressing this button will start the selected program number
displayed in the 2-digit display.
Special Function Button
Press Special Function to perform furnace setup.
Special functions are covered in detail in Chapter Four —
Running a Program.
Keypad
The keypad is used to enter numeric data.
Enter Button
Press the Enter button to:
• storetheinputdata.
• proceedtothenextitemwhenenteringinputinformation.
• clearanerrormessageonthedisplay.
Program Select Button
Used to select a program to run. Valid program numbers
are from 1 through 50.
• PresstheProgram Select button.
• Inputthedesiredprogramnumberyouwishtorun.The
program number will be displayed in the 2-digit display.
• PresstheStart Program button to start the program
shown in the 2-digit display.
Note: Program number 0 is a special program. DO NOT run
or use program number 0 to edit or store your program.
Program Edit Button
• PressingProgram Edit allows you to edit a program.
Editing programs is covered in detail in Chapter Two —
Special Functions Input.
• PressingProgram Edit while a program is running will
allow you to make temporary changes to the program
currently running. After the changed program has run,
the program will revert to its original values. Changing
programs is covered in detail in Chapter Three —
Entering and Editing Programs.
Up/Skip Button
• Whileinidlemode,pressthe /Skip once and the lift
moves upward. Press again and the lift stops moving.
• Whiletheliftismovingdown,pressthe /Skip and the
lift will begin moving up.
• Whileaprogramisrunning,pressthe /Skip and the
program will skip to the next step. For example, pressing
the
/Skip button during the soak time will advance
the program to the rise rate. Pressing
/Skip again will
advance to the final temperature.
Down/Abort Button
• Whileinidlemode,pressthe /Abort once and the
lift moves downward. Press again and the lift will
stop moving.
• Whiletheliftismovingup,pressthe
/Abort and the
lift will begin moving down.
• Whileaprogramisrunning,pressingthe /Abort will
cause the program to abort and the lift to move to its
lower position.
• Pressthe
/Abort while changing a program or while
entering a special function and the program entry or
special function will abort without changing the previous
contents of the program or special function.
• Whileinanymode,pressthe
/Abort and the furnace
will return to idle mode.
Changing Units of Measure Between
English and Metric
The furnace can be changed from Metric to English units
of measure or from English to Metric units while in idle
mode. Programmed values are automatically converted.
Follow these steps to convert from Metric
to English:
1. Press the Special Function button.
2. Press 2 on the keypad.
3. Press the Enter button.
Follow these steps to convert from English
to Metric:
1. Press the Special Function button.
2. Press 1 on the keypad.
3. Press the Enter button.