Installation Instructions
- 4 -
3.System power off.
12
HOST
Lock
Power input 12V±0.1V
Place the smart key within
the surface of the LF antenna
150cm.
1.Power Bottom pressed
300ms.
2.Positioning signal Pull
Low.
3. During the warning
reminder time, after the
positioning signal Pull Low
is released
1.停止警示提，並執行上鎖。
2. The buzzer sounds for 500ms.
3.Red LED light up for 2 seconds.
□OK □NG
13
HOST
Lock
Power input 12V±0.1V
Place the smart key within
the surface of the LF antenna
150cm.
Turn the dial to switch the
IGN status
IGN OFFIGN ON IGN
OFF one time.
1.Power Bottom pressed
300ms
2. Positioning signal Pull
High.
1. System execution lock.
2. The buzzer sounds for 500ms.
3. Red LED light up for 2 seconds.
□OK □NG
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.