Installation Instructions

- 2 -
remove battery or disconnect
LF antenna。
 If identification Pass, system
unlock
4.Red LED lights up for 2
seconds 。
5.Extinguish the blue LED。
3
HOST
Lock(Immo Coil)
 Power input 12V±0.1V
 Place the smart key on the
surface of the Immo. Coil
2.5mm
 The smart key need to
remove battery or disconnect
LF antenna。
Turn the dial to switch the
IGN status
IGN OFFIGN ON IGN
OFF one time.
1. Identification after every 3
seconds.
2. If identification fail，system will
lock.
3. The buzzer sounds for 500ms.
4. Red LED lights up for 2
seconds.
5. Extinguish the blue LED.
□OK □NG
4
HOST
Unlock(Immo Coil)
 Power input 12V±0.1V
Change IGN OFF/IGN
OFF2 Switch to IGN ON
1.System will lock
2. Blue LED will light up slowly
□OK □NG
5
HOST
Identification
Pass(Antenna)
 Power input 12V±0.1V.
 Place the smart key within
the surface of the LF antenna
150cm.
 The lock is locked.
Power Bottom pressed
300ms
1. If identification is successfully ,
the drive lock is unlocked, and the
blue LED will slowly light up.
2. Buzzer short beep 2
(ON/OFF:100ms/100ms)
□OK □NG
6
HOST
Identification
fail(Antenna)
 Power input 12V±0.1V
 Place the smart key outside
the surface of the LF antenna
300cm.
 The lock is locked.
1.Place the smart key
outside the surface of the
LF antenna 300cm.
2.Power Bottom pressed
300ms.
If identification failed, no action is
taken, the host goes into standby
□OK □NG
7
HOST
Identification
margi(Antenna)
 Power input 12V±0.1V
 Place the smart key within
the surface of the LF antenna
1.Power Bottom presses
300ms for system unlock.
2. Place the smart key
1. The system first recognizes the
unlock and then enters the 3
second identification.
□OK □NG