Product Manual

Page 1
©2005 Whelen Engineering Company Inc.
Form No.13979D (082807)
Route 145, Winthrop Road,
Chester, Connecticut 06412
Phone: [phone]
Fax: [phone]
Automotive: Lightheads
Installation Guide:
5G-series Warning Lighthead
®
ENGINEERING COMPANY INC.
Internet: www.whelen.com
Sales e-mail: [e-mail]
Canadian Sales e-mail: [e-mail]
Customer Service e-mail: [e-mail]
©2005 Whelen Engineering Company Inc.
Form No.13979D (082807)
Route 145, Winthrop Road,
Chester, Connecticut 06412
Phone: [phone]
Fax: [phone]
Automotive: Lightheads
Installation Guide:
5G-series Warning Lighthead
®
ENGINEERING COMPANY INC.
Internet: www.whelen.com
Sales e-mail: [e-mail]
Canadian Sales e-mail: [e-mail]
Customer Service e-mail: [e-mail]
Installation:
1. After marking onto the mounting
surface the measurements shown
here, drill the two 1.25” radius holes,
then cut out the center area as
shown.
2. Install the rubber grommet into the
vehicle, then snap the lighthead into
the rubber grommet.
3. Extend the wires to your power
source. Fuse the power wire at 1
AMP.
Wiring:
WARNING! All customer supplied wires that connect to the positive terminal of the battery must be sized to
supply at least 125% of the maximum operating current and FUSED at the battery to carry that load. DO NOT
USE CIRCUIT BREAKERS WITH THIS PRODUCT!
See reverse for wiring information, specifications and operation of the lighthead.
(4 )
1
4
4.25
(1 )
1
4
1.25 RADIUS
(1 )
1
4
1.25 RADIUS
MOUNTING HOLE
(CUT-OUT)
MOUNTING SURFACE
Installation:
1. After marking onto the mounting
surface the measurements shown
here, drill the two 1.25” radius holes,
then cut out the center area as
shown.
2. Install the rubber grommet into the
vehicle, then snap the lighthead into
the rubber grommet.
3. Extend the wires to your power
source. Fuse the power wire at 1
AMP.
Wiring:
WARNING! All customer supplied wires that connect to the positive terminal of the battery must be sized to
supply at least 125% of the maximum operating current and FUSED at the battery to carry that load. DO NOT
USE CIRCUIT BREAKERS WITH THIS PRODUCT!
See reverse for wiring information, specifications and operation of the lighthead.
(4 )
1
4
4.25
(1 )
1
4
1.25 RADIUS
(1 )
1
4
1.25 RADIUS
MOUNTING HOLE
(CUT-OUT)
MOUNTING SURFACE
For warranty information regarding this product, visit www.whelen.com/warranty
For warranty information regarding this product, visit www.whelen.com/warranty