Owner`s manual

Wheeltech Monte Carlo Electric Scooter Page 20 of 20 Owner’s Handbook (Part Code: Z40969)
7. Unplug the front-to-rear harness
(blue and red connector).
8. Press down on the rear bumper
to pivot the scooter’s rear section
rearwards until the rear section is
standing vertically on its rear
bumper.
9. Lift the front section until the
lower pegs are no longer in the
curved locking brackets. Carefully
lift the front section away from the
rear section.
7.8 ASSEMBLING THE SCOOTER
& Suggestions
The assembly process is essentially the disassembly process in reverse. First study the text and photographs
in the disassembly procedure before re-assembling the scooter.
1. Position the front and rear sections of the Monte Carlo 4.
2. Align the lower curved locking brackets of the front section with the corresponding pegs on the front of
the rear section.
3. Holding the seat post, slowly pivot the rear section forward until the curved locking brackets are fully
connected on to the top rear pegs.
4. Secure the lock pin in to the pin hole
5. Loosen the tiller adjustment knob, raise the tiller to the desired position, and then tighten the tiller
adjustment knob.
6. Reinstall the batteries and secure them with the Velcro strap.
7. Connect the front-to-rear harness and battery cables.
8. Reinstall the rear shroud.
9. Replace the seat and rotate it until it locks in to its correct position.
N Warning
After assembling the Monte Carlo 4, make absolutely certain the tiller adjustment knob is fully tightened.