Owner`s manual

Apollo Owner’s Manual (Part Code: Z40977-00 Rev A) Page 6 of 11
SEAT REMOVAL AND INSTALLATION
TO REMOVE THE SEAT WITH THE SEAT STEM
1. Ensure the seat is in one of the ENGAGED positions (see diagram below)
2. Remove the seat stem locking pin (see Parts Description).
3. Pull the seat up.
TO INSERT THE SEAT WITH THE SEAT STEM
1. Insert the seat stem in to the scooter
2. Line up the holes at the required height and insert the seat stem locking pin through the
scooter and seat stem.
3. Adjust the seat if necessary by following the guidelines below.
TO ROTATE THE SEAT
The seat comes with four engaged positions (see diagram below). To rotate the seat from
another engaged position first lift up the seat lever. Keep the lever held up and rotate the seat
to the required engaged position (see diagram below). Release the lever and twist the seat
slightly until it locks in position. Check the seat is locked in position by trying to twist the
seat. If the seat is locked in position no twisting should occur.
TO REMOVE THE SEAT WITHOUT THE SEAT STEM
1. Lift up the seat lever and turn the seat slightly to disengage the seat lock. Slowly rotate
the seat approximately 45° until you hear a loud click from under the seat.
2. The lever should now be lower than before and the seat in one of the removal positions
shown in the diagram below.
3. Lift the seat up
TO INSERT THE SEAT WITHOUT THE SEAT STEM
1. Insert the seat stem at one of the removal positions shown in the diagram below.
2. Lift up the seat lever.
3. Keep the lever held up and rotate the seat to the required engaged position (see diagram
below). Release the lever and twist the seat slightly until it locks in position.
4. Check the seat is locked in position by trying to twist the seat. If the seat is locked in
position no twisting should occur.
Above: Seat shown in the four possible "ENGAGED" positions
Below: Seat shown in the four possible "REMOVABLE" positionS