Technical data

Chapter 4: Installation

4.9.2 Installing Batteries

NOTE: Batteries are not supplied with the SP40S Multi-Function Facility Communication System and must be

purchased separately.

1. Connect the supplied red battery wire to the (+) terminal and the supplied black battery wire to the (–)

terminal of TB10 (see Figure 4-14).

2. Run jumpers along the bottom of the chassis in the battery compartment.

To Positive

(+) of battery

terminal

(Red)

To Negative

(-) of battery

terminal

(Black)

Figure 4-14 Battery Wire Connections

3. Refer to Figure 4-15 and place one 12-Volt battery with the battery terminals on top and to the right.

Place the second battery to the right of the first battery with the battery terminals on top and to the left.

SP40S Multi-Function Facility Communication System Manual, Revision D