Specifications

When finished, open the File menu. Select Save As…

Enter the name of the file and click the Save button. See Figure below.

Complete the task by clicking on the “Send Configuration” command button. This sends the new

configuration to the SP4-TZC. Notice that the “Zone Controller Successfully Programmed”

message appears on the computer screen, and that the USB CONFIG LED indicator on the SP4-

TZC PC board turns ON. If an Error message appears, refer to Section 5.6 for details and

corrective action.

Test the Zone Paging setup.

Shut down the SP4 Telzone Programmer 2 software on the host computer.

Disconnect the USB cable from the SP4-TZC Zone Controller and the host computer.

3.8 Editing Silence Detection Timeout

Connect the USB cable from the USB port on the SP4-TZC Zone Controller to the configured

USB port on the host computer. Make sure that the SP40, all audio boosters and SP4-APS

splitters are properly connected and powered up.

Start the SP4 Telzone Programmer 2 software.

NOTE: Before creating a new setup file, always save the current file.

Notice that the file name is Setup.tzc. Do one of the following:

a. If you wish to obtain and view the present Zone Paging Options, click the “Get

Configuration” command button. Then proceed to Step 4.

b. If you wish to select a previously saved setup file, select the File menu and click on

Open. Select the desired file. Then proceed to Step 4.

c. If you wish to create a new setup file, select New from the File menu to open the Wizard

and begin. Refer to section 3.5.1.

STEP 6

STEP 7

STEP 8

STEP 9

STEP 2

STEP 3

STEP 1STEP 1

STEP 10

STEP 11