Specifications

Click the OK button on the “Zone Controller Successfully Programmed” message.

Close the SP4 Telzone Programmer 2 software.

Disconnect the USB cable from the SP4-TZC Zone Controller and the host computer.

3.5.2 Manually Programming/Editing Logical Zone Groups

Connect the USB cable from the USB port on the SP4-TZC Zone Controller to the configured

USB port on the host computer. Make sure that the SP40, all Audio Boosters and SP4-APS

splitters are properly connected and powered up.

Start the SP4 Telzone Programmer 2 software.

NOTE: Before creating a new setup file, always save the current file.

Notice that the file name is Setup.tzc. Do one of the following:

a. If you wish to obtain and view the present setup of Logical Zone Groups, click the “Get

Configuration” command button. Then proceed to Step 4.

b. If you wish to select a previously saved setup file, select the File menu and click on

Open. Select the desired file. Then proceed to Step 4.

c. If you wish to create a new setup file, select New from the File menu to open the Wizard

and begin. Refer to section 3.5.1.

STEP 1

STEP 2

STEP 3

STEP 17

STEP 18

STEP 1

STEP 19