Specifications

Click the “Finish” command button. The main screen will appear. See Figure below.

To skip programming of Logical Zone Groups, or if Zone Paging is Disabled, go to STEP 14.

Otherwise enter the name of the Logical Zone Groups and enter the Zone Codes for the Individual

Zones and/or Fixed Zone Groups for each Logical Zone Group.

Enter the name of the Logical Zone Groups and enter the Zone Codes for the Individual Zones

and/or Fixed Zone Groups for each Logical Zone Group.

Save the file by opening the File menu and clicking Save. The following screen will appear:

Verify the file name before saving, and then click the Save button.

In order to configure the SP4-TZC Zone Controller with the new setup, click the “Send

Configuration” command button. If an Error message appears, refer to Section 5.6 for details and

corrective action.

STEP 15

STEP 16

STEP 11

STEP 12

STEP 13

STEP 14