Specifications

Chapter 2

Installation Procedures

2.1 Notes, Cautions, and Warnings

NOTE: All CAUTIONS and WARNINGS are identified by the symbol . All warnings are printed in bold

capital letters.

WARNING: PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS

PRODUCT. FAILURE TO COMPLY WITH ANY OF THE FOLLOWING

INSTRUCTIONS, CAUTIONS AND WARNINGS COULD RESULT IN IMPROPER

APPLICATION, INSTALLATION AND/OR OPERATION OF THESE PRODUCTS

IN AN EMERGENCY SITUATION, WHICH COULD RESULT IN PROPERTY

DAMAGE AND SERIOUS INJURY OR DEATH TO YOU AND/OR OTHERS.

NOTE: Observe all electrical and electronic safety precautions.

This manual assumes that the SP40 has been installed according to the SP40 Installation Manual

(P84116) and that the SP4-APS splitter is properly installed according to the SP4-APS Installation

Procedure (P84577) in the SP40 enclosure. It also assumes that all Audio Boosters (SPB-80/4, SPB-160,

SPB-320) are properly wired according to the SPB-80/4 and SPB-160 Audio Booster Installation Manual

(P84296) and/or the SPB-320 (P84244) Installation Manual, and that the SP4-APS splitters are properly

installed.

WARNING: BEFORE INSTALLING THE SP4-TZC ZONE CONTROLLER, MAKE SURE THE

POWER IS TURNED OFF AND BATTERIES REMOVED TO ALL COMPONENTS

OF THE SAFEPATH

4 MULTI-FUNCTIONAL FACILITY COMMUNICATIONS

SYSTEM.

2.2 Telephone Page Zone Control Mapping Guide

Appendix A, at the back of this manual is a Telephone Page Zone Control Mapping Guide which can be used to

map the zone locations and Zone Codes. This can assist the technician as well as the user in identifying the

locations of the paging zones. The user can create a directory from this guide.

2.3 Mounting

Perform the following steps using Figure 4 as a reference:

Remove the 4 sheet metal screws from the front cover and remove the front cover.

Mount the SP4-TZC to the wall next to the SP40 enclosure using the two keyholes and the two

circular holes provided in the base. Be sure to use mounting hardware suitable for the mounting

surface.

As required, remove the 3/4" knockouts on the top and bottom of the enclosure for conduit or wire

runs.

STEP 1

STEP 2

STEP 3