Specifications

34
Complete the task by clicking on the “Send Configuration” command button. This sends the
new configuration to the SP4-TZC. Notice that the “Zone Controller Successfully
Programmed” message appears on the computer screen, and that the USB CONFIG LED
indicator on the SP4-TZC PC board turns ON. If an error message appears, refer to
Section 5.6 on Page 44 for details and corrective action.
Click the “OK” command button on the “Zone Controller Successfully Programmed”
message.
Test the Background Music Zone. If they are correct, go to STEP 9. If there is an error go to
STEP 1 of this process.
Shut down the SP4 Telzone Programmer software on the host computer.
Disconnect the USB cable from the Zone Controller and the host computer.
3.7 Uninstalling the SP4 Telzone Programmer Software
NOTE: Make sure that the SP4 Telzone Programmer software is not running on the host computer and
that the USB cable has been disconnected from the SP4-TZC and the host computer.
On the Windows screen go to Start, Settings, Control Panel, Add/Remove Programs.
Remove the SP4 Telzone Programmer software.
Remove the USB Driver (FTDI FTD2XX).
This completes the un-installation process.
STEP 6
STEP 7
STEP 8
STEP 1
STEP 2
STEP 3
STEP 4
STEP 9
STEP 10