Specifications

32
Test the Logical Zone Group changes. If they are correct, go to step 9. If errors occur, go to
step 1.
If editing of the Background Music Zone is required, proceed to Section 3.6.1 on Page 33.
If editing has been completed, open the File menu and click the Save item on the menu. If a
new name is required, click the “Save As…” item on the menu. Enter the new name and click
the Save command button.
Complete the task by clicking on the “Send Configuration” command button. This sends the
new configuration to the SP4-TZC. Notice that the “Zone Controller Successfully
Programmed” message appears on the computer screen, and that the USB CONFIG LED
indicator on the SP4-TZC PC board turns ON. If an error message appears, refer to
Section 5.6 on Page 44 for details and corrective action.
Click the “OK” command button on the “Zone Controller Successfully Programmed”
message.
Test the Logical Zone Groups. If they are correct, go to STEP 13. If there is an error go to
Step 1 of this process.
Shut down the SP4 Telzone Programmer software on the host computer.
Disconnect the USB cable from the Zone Controller and the host computer.
STEP 7
STEP 8
STEP 9
STEP 10
STEP 11
STEP 12
STEP 13
STEP 14