Specifications

3.5.2 Manually Programming Logical Zone Groups

Connect the USB port on the SP4-TZC to the USB port on the host computer. Make sure that

the SP40/2, all audio boosters and SP4-APS splitter modules are properly connected and

powered up.

3.5.2.1 Setting Up

NOTE: Before creating a new setup file, always save the current file.

Start the SP4 Telzone Programmer software.

Notice that the File name is Setup.tzc. Do one of the following:

a. If you wish to view the present setup of the Logical Zone Groups and edit those,

click the “Get Configuration” command button.

b. If you wish to select a previously programmed file, select the File Menu and click on

Open. Select the desired file.

c. If you wish to create a new zone setup, select New from the File menu to open the

Wizard and begin. Refer to section 3.5.1 on Page 25.

3.5.2.2 Programming the Logical Zone Groups Without Using the Wizard Feature

Select the “Audio Class of wiring” for the connected SP4-APS splitters. Remember, all

splitter Class of Wiring setting must be the same.

Select the corresponding number of splitters in the “Number of Splitters” box. The maximum

number of splitters is 17.

STEP 1

STEP 2

STEP 3

STEP 1

STEP 2