Specifications

3.3 Installing the USB Driver

After the SP4 Telzone Programmer software has been installed on the host computer, the proper USB

driver must be installed. The following is the procedure:

Install the SP4 Telzone Programmer software CD in the CD-ROM drive on the computer.

Connect the USB cable between the computer and the SP4-TZC USB port.

NOTE: Use the USB Cable supplied with the Wheelock Part TZC-USB. The USB cable cannot exceed 10

feet in length. See Section 1.2.2 on Page 9 for a description of the connectors on the USB cable.

Power ON the SP4-TZC module by energizing the separate 24VDC power supply.

The “Found New Hardware” wizard indicates that new hardware has been found, and prompts

the user for the location of the USB driver. Locate the USB driver on the SP4 Telzone

Programmer Software CD. Follow the directions on the screen and complete the installation

of the USB driver.

3.4 SP4 Telzone Programmer Main Screen

Refer to Figure 14 on Page 23 for the explanation of areas of the main screen.

3.4.1 Menu Bar

Traditional Windows style Menu Bar where you can access all the SP4 Telzone Programmer software

features.

3.4.1.1 File Menu

Contains menu items and keyboard shortcuts to create a new setup using the SP4 Telzone Programmer

wizard, open an existing setup file, and save changes. It also lists current SP4 Telzone Programmer

setup files that are in the system.

STEP 1

STEP 2

STEP 3

STEP 4