Specifications

Chapter 2 Installation Procedures

2.1 Notes, Cautions, and Warnings

NOTE: All CAUTIONS and WARNINGS are identified by the symbol

. All warnings are printed in

bold capital letters.

WARNING: PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS

PRODUCT. FAILURE TO COMPLY WITH ANY OF THE FOLLOWING

INSTRUCTIONS, CAUTIONS AND WARNINGS COULD RESULT IN

IMPROPER APPLICATION, INSTALLATION AND/OR OPERATION OF

THESE PRODUCTS IN AN EMERGENCY SITUATION, WHICH COULD

RESULT IN PROPERTY DAMAGE AND SERIOUS INJURY OR DEATH TO

YOU AND/OR OTHERS.

NOTE: Observe all electrical and electronic safety precautions.

This manual assumes that the SP40/2 has been installed according to the SP40/2 Installation manual

(P84116) and that the SP4-APS splitter is properly installed according to the SP4-APS Installation

Procedure (P84577) in the SP40/2 enclosure. It also assumes that all Audio Boosters (SPB-80/4, SPB-

160, SPB-320) are properly wired according to the SPB-80/4 and SPB-160 Audio Booster Installation

Manual (P84296) and/or the SPB-320 (P84244) Installation Manual, and that the SP4-APS splitters

are properly installed.

WARNING: BEFORE INSTALLING THE SP4-TZC ZONE CONTROLLER, MAKE SURE

THE POWER IS TURNED OFF AND BATTERIES REMOVED TO ALL

COMPONENTS OF THE SAFEPATH

4 MULTI-FUNCTIONAL FACILITY

COMMUNICATIONS SYSTEM.

2.2 Telephone Page Zone Control Mapping Guide

Appendix A, at the back of this manual is a Telephone Page Zone Control Mapping Guide which can be

used to map the zone locations and zone codes. This can assist the technician as well as the user in

identifying the locations of the paging zones. The user can create a directory from this guide.

2.3 Mounting

Perform the following steps using Figure 4 on Page 12 as a reference:

Remove the 4 sheet metal screws from the front cover and remove the front cover.

Mount the SP4-TZC to the wall next to the SP40/2 Enclosure using the two keyholes and the

two circular holes provided in the base. Be sure to use mounting hardware suitable for the

mounting surface.

Remove the 3/4" knockouts on the top and bottom of the enclosure for conduit or wire runs as

desired.

STEP 1

STEP 2

STEP 3