Instruction manual

5
-
2
Procedure for Recording Messages on the Digital Voice Section
CAUTION: Recording of any new message will permanently erase the previous message. If
a Wheelock, Inc. factory prerecorded fire or emergency message, or a tailored message is
accidentally or intentionally erased, a new factory recorded message kit must be purchased to restore
the message.
Refer to Figure 5-1 (Page 5-2) for location of all Digital Voice Section operating components. Decide
which message segment that the recording will be made on. Read through this procedure carefully
before attempting a recording. Identify all components mentioned.
1. Remove the DV Record Jumper W-1. Place jumper in a secure place. It will be replaced at
the end of the recording procedure.
2. Turn switch 4 (R) on the DV Select DIP Switch (SW3) to the up or ON position.
3. Determine which one of the three messages you wish to record.
4. With the mouth approximately one inch from the DV Microphone and the right hand on the
proper message switch on SW3 (DV Select Switch) 1, 2, or 3, turn ON or to the up position,
the desired switch and immediately state the message.
5. When the message has concluded turn OFF switch 4 (R) on the DV Select Switch (SW3).
6. Turn OFF the selected switch on SW3.
7. Check recorded message by momentarily turning ON the selected switch on the DV Select
Switch (SW3). The message will play in its entirety.
8. For additional message recording, repeat steps 2 through 7.
9. When recording is done replace DV Record Jumper (W1).
Procedure for Verifying Messages
NOTE: Verify SW3 DIP switch, position 4 (R) is in the OFF position.
1. Momentarily switch on selected switch on the DV Select Switch (1, 2, or 3) (SW3). The
message will play in its entirety.
2. Adjust R126 (treble) and R129 (bass) tone controls for desired output.