Instruction manual

5-3
! Warning:
When the GREEN “NORMAL” LIGHT
Is ON, the system is functioning
Properly.
When the YELLOW “TROUBLE LIGHT
is ON, there is a FAULT in the
system which MUST BE CORRECTED.
IF THE YELLOW “TROUBLE” LIGHT IS ON,
THIS UNIT MAY NOT BE ABLE TO PROVIDE
EMERGENCY MESSAGE ANNOUNCEMENT
CAPABILITIES AND COULD RESULT IN PROPERTY
DAMAGE. SERIOUS INJURY OR DEATH TO YOU
AND/OR OTHERS. IN THE EVENT THE
“TROUBLE” LIGHT IS ON, YOU SHOULD CONTACT
YOUR SERVICE REPRESENTATIVE IMMEDIATELY.
ACKNOW LEDGEMENT
To Acknowledge a Trouble Condition:
1. Momentarily slide the TROUBLE/
ACKNOW LEDGE switch down to
the ACKNOW LEDGE position.
This will only silence the internal
Sounder and any external trouble
signaling devices. The system will
remain in a trouble condition with
the yellow “TROUBLE” light on and
the system trouble contact will
remain in the trouble position until
all trouble conditions have been
corrected.
MANUAL OPERATION
To Sound Evacuation Tone:
1. Switch MANUAL/AUTOMATIC switch
DOW N to the MANUAL position.
MICROPHONE OPERATIONS
1. Hold the microphone within two
inches of mouth and press
push-to-talk switch on
microphone.
2. Deliver message. Activation of
the microphone will deliver the
message to all circuits.
RESET
To Turn Off Strobes:
1. All initiating circuits must be reset.
2. Momentarily slide the RESET
switch to the RESET position.
FOR ADDITIONAL INFORMATION
REFER TO OPERATION AND
INSTALLATIONMANUAL.
STATUS
TROUBLE
NORMAL
AUTOMATIC
TROUBLE
MANUAL
RESET
ACKNOWLEDGE
Figure 5-1
Single Circuit SAFEPATH
®
Panel Operator Console