Instruction manual

3-25
Table 3-4
Standby Current for Dual-Circuit SAFEPATH
®
Panel
Model
Standby Current
per UL Full Power
SIN Wave Testing
1
Standby Current
when DCDC is in
Temporal Code 3
Tone
2
Standby Current
when DCDC is in
HI/LO
3
(Worst Case
Tone)
DCSP-4RP 0.630 Amps 0.530 Amps 0.530 Amps
DCSP-4RP + SAA-40S 1.030 Amps 0.830 Amps 0.830 Amps
DCSP-4RP + SAA-80S 1.230 Amps 0.830 Amps 0.930 Amps
DCSP-4RP + SALL-15S 0.730 Amps
4
0.630 Amps
4
0.630 Amps
4
DCSP-8RP 0.830 Amps 0.530 Amps 0.630 Amps
DCSP-8RP + SAA-40S 1.230 Amps 0.830 Amps 0.930 Amps
DCSP-8RP + SAA-80S 1.430 Amps 0.830Amps. 1.030 Amps
DCSP-8RP + SALL-15S 0.930 Amps 0.630 Amps 0.730 Amps
DCSP-15SP 0.330 Amps 0.330 Amps 0.330 Amps
DCSP-15SP + SAA-40S 0.730 Amps 0.630 Amps 0.630 Amps
DCSP-15SP + SAA-80S 0.930 Amps 0.630 Amps 0.730 Amps
DCSP-15SP + SALL-15S 0.430 Amps 0.430 Amps 0.430 Amps
1
The UL Test is performed with the amplifiers out of the Panel and in a bench test condition.
2
This column uses the standard current calculation when Temporal Code 3 is selected on the
Control Module (DCDC). This is the recommended configuration for operation.
3
This column shows the current value of the Panel with the Control Module configured on the
highest current reading (HI/LO).