Instruction manual

2-3
Section 2-2 - Enclosure and Configuration
See Chapter 8 for Technical Specifications
Section 2-3 - Nominal Electrical Data
See Chapter 8 for Technical Specifications.
Section 2-4 - Module Configurations
The Dual-Circuit SAFEPATH
®
Panel is equipped with a combination of the following modules:
There are twelve modules in the Dual-Circuit SAFEPATH
®
Panel product line.
The twelve modules are:
DCMB (Dual-Circuit Mother Board)
DCDC (Dual-Circuit Control Module)
DCPS (Dual-Circuit Power Supply)
SAA-40S (40 Watt Supervised Audio Amplifier with 2 Amps of Synchronized Strobe Power)
SAA-80S/SE* (80 Watt Supervised Audio Amplifier with 2 Amps of Synchronized Strobe Power)
SALL-15S (Line Level Module Supervised Audio Amplifier with 2 Amps of Synchronized Strobe
Power)
SPL (Dual or Multi-Circuit Speaker Circuit Splitter, 4 zone)
NACIM (Notification Appliance Circuit Interface Module)
MDX-2 (Modular Digital Voice Module (MDX-2)
AM-MDV-OCM (OptionalOutput Channel Module for MDX-2)
RMS-3 (Dual-Circuit Remote Microphone Station)
AIM-3 (Auxiliary Input Module FOR telephone Interface and Multiple Remote Microphone
Stations)
RAM-1 (1 FOR 1 Redundant Amplifier Module)
* 100-Volt Export Installations
Section 2-5 - Dual-Circuit
SAFEPATH
®
Panel Basic Configuration
Each Dual-Circuit SAFEPATH
®
panel is configured with:
DCMB (Dual-Circuit Mother Board)
MDX-2 (Digital Voice Module)
SMK (Standard Message Kit) or PMK (Programmed Message Kit)
DCDC (Dual-Circuit Control Module)