Installation manual

SAFEPATH Manual Sheet 62 of 78
Rev. C April 1999
Module Description
Introduction
There are fifteen modules in the SAFEPATH product line.
The fifteen modules are:
1. Supervised Audio System Mother Board (SAMB-A)
2. Supervised Audio System Common Control Module (SADC)
3. Supervised Audio System Amplifier/Signal Circuit Module (SAA)
4. Supervised Audio System Amplifier/Signal Circuit Module (SAA-10)
5. Supervised Audio System Amplifier/Signal Circuit Module (SAA-10E)
6. Supervised Audio System Amplifier/Signal Circuit Module (SAA-40A)
7. Supervised Audio System Amplifier/Signal Circuit Module (SAA-40AE)
8. Supervised Audio System Amplifier/Signal Circuit Module (SAA-80)
9. Supervised Audio System Amplifier/Signal Circuit Module (SAA-80E)
10. Self Amplified Speaker Control/Signal Circuit Module (SACM-4)
11. Supervised Audio System Power Supply Module (SAPS)
12. Supervised Audio System Battery Charger Module (SABC)
13. Digital Voice Module with Playback (DX-100)
14. Digital Voice Module with Record and Playback (DX-200)
15. Remote Microphone Station (RMS-1)
Each SAFEPATH panel is configured with:
•
One SAMB-A
•
One SADC
•
Between one and four amplifier modules (any combination of SAA’s and SACM-4’s)
•
One SAPS
•
One SABC
•
One digital voice module (either a DX-100 or a DX-200)
The interior view of the SAFEPATH panel with the modules in place is shown in Figure 30. The location of the amplifier modules
(SAA and SACM-4) is not shown. The amplifier modules may be used in any combination by installing into slots 1 thru 4 in the
SAMB-A. A block diagram of the SAFEPATH panel is shown in Figure 31.