Installation manual

Remote SAFEPATH Manual Sheet 39 of 50

Rev. C December 1998

Module Description

Introduction

The thirteen modules in the SAFEPATH product line which can be used in the Remote SAFEPATH are:

1. Supervised Audio System Mother Board (SAMB-A)

2. Supervised Audio System Common Control Module (SADC)

3. Supervised Audio System Amplifier/Signal Circuit Module (SAA-10S)

4. Supervised Audio System Amplifier/Signal Circuit Module (SAA-10SE)

5. Supervised Audio System Amplifier/Signal Circuit Module (SAA-40S)

6. Supervised Audio System Amplifier/Signal Circuit Module (SAA-40SE)

7. Supervised Audio System Amplifier/Signal Circuit Module (SAA-80S)

8. Supervised Audio System Amplifier/Signal Circuit Module (SAA-80SE)

9. Self Amplified Speaker Control/Signal Circuit Module (SALL-15S)

10. Supervised Audio System Power Supply Module (SAPS)

11. Supervised Audio System Battery Charger Module (SABC)

12. Remote Microphone Station (RMS-1)

13. Line Level Interface Module (LLIM)

Each SAFEPATH panel is configured with:

• One SAMB-A

• One SADC

• Between one and four amplifier modules (any combination of SAA’s and SALL-15S’s)

• One SAPS

• One SABC

• One LLIM

The interior view of the panel with the modules in place is shown in Figure 22. The location of the amplifier modules (SAA and

SALL-15S) is not shown. The amplifier modules may be used in any combination by installing into slots 1 thru 4 in the SAMB-A. A

block diagram of the panel is shown in Figure 23.