Instruction manual

P83259 H
Sheet 22 of 26
17. PROGRAMMING INSTRUCTIONS:
The MZC-144 supports the following commands.
1. Program a Logical Zone Group.
2. Delete a Logical Zone Group.
3. Delete all Logical Zone Groups.
Programming a Logical Zone Group:
1. Access the MCZ-144.
2. Dial a “#11*”.
3. Dial the Logical Zone Group to be programmed (301-325).
4. Dial a “*”.
5. Dial up to (5) Zones, Fixed Zones or any combination of them. With an “*” separating each of the Zones or Fixed Zones.
6. The final step in the programming process is to enter a “#” as an end signal to the MZC-144 and the programming will
proceed.
7. If the programming is successful, you will hear a long beep then you can program another Logical Zone by repeating steps
two through seven.
8. If the programming is not successful, there will be three short beeps and the MZC-144 will disconnect.
The following is an example of how to program a Logical Zone Group:
#11*301*001*203*005# - This programs Logical Zone Group 301 with zones 001, 005 and Fixed Zone Group 203.
Deleting a Logical Zone Group:
1. Access the MZC-144.
2. Dial a “12*”.
3. Dial the Logical Zone Group to be deleted (301-325).
4. Dial a “#”.
5. If the deletion is successful you will hear a long beep then you can delete another Logical Zone by repeating steps 2
through 5. If the deletion is not successful there will be three short beeps and the MZC-144 will disconnect.
The following is an example of how to delete a Logical Zone Group:
#12*301# - This deletes Logical Zone Group 301.
Deleting All
Logical Zone Groups:
CAUTION: This will remove all programmed logical zone groups. At any time during the dialing sequence, the user may hang-
up and the command will be canceled.
1. Access the MZC-144.
2. Dial #13*999*999*999#