Instruction manual
Section 4
Installation
4.1 Mounting
The PS2 is available only as a board level supply, while the PS3 and PS5 are available in either
board-level or cabinet level versions.
4.1.1 Mounting a Cabinet-Level Supply
If the PS3/5 is provided in a wall mount enclosure, use #8 hardware minimum in four locations.
Use an appropriate fastening system for the mounting surface.
Cabinet Mounting:
1. Mark and predrill two holes for the top keyhole mounting screws
2. Install two fasteners in the mounting wall leaving screwheads protruding approximately ΒΌ
inch
3. Using the two upper keyholes, mount the cabinet over the two screws
4. Mark the two lower holes, remove the cabinet and drill the lower mounting holes
5. Mount the cabinet, install the remaining fasteners, and tighten all fasteners
BN
ABC
Figure 4.1.1
4.1.2 Mounting a Board-Level Supply
Board-level, supplies can be mounted either with the provided double-sided tape or by using
nylon standoffs and hardware (not included). Replacement boards for a listed supply must reuse
the existing hardware to maintain the listing.
PS2/3/5 Installation Instructions
8/23/2007, 2:51:41 PM
52-133 Rev B.01
Page 10 of 16
AlarmSaf 65A Industrial Way, Wilmington, MA 01887 978 658 6717 www.alarmsaf.com