Specifications

Hardware Installation
151117 4-9
4.8.3 Setting the SK-2866’s Address
The range of valid addresses is 0-3. Each device requires a unique address. Set the dip
switches as shown in Table 4-4. See Figure 4-8 for dip switch location.
4.8.4 Mounting the SK-2866
The SK-2866 mounts in a standard 3-gang electrical box.
Follow these steps to mount the SK-2866:
1. Make sure that the SK-2866 is properly wired to the control panel. See Figure 4-8.
2. Slide the printed annunciator label into place on the SK-2866. The label fits between the
LEDs and the clear plastic plate. See Figure 4-9.
Table 4-3: SK-2866 Wiring Connections
SK-2866
Terminals
SK-6324
Terminals
D (Data) D (Data)
++
--
Table 4-4: Addresses Per Dip Switch Setting
Dip Switch Position Address
Both Open (off) 0
One Closed (on) 1
Two Closed (on) 2
Both Closed (on) 3