Instruction manual

P83567 C

Sheet 6 of 10

WARNING: THE SPEAKER AND SPEAKER STROBE APPLIANCES MUST BE FIELD SET TO THE DESIRED dBA

SOUND OUTPUT LEVEL BEFORE THEY ARE INSTALLED. THIS IS DONE BY PROPERLY INSERTING JUMPER

PLUGS IN ACCORDANCE WITH THESE INSTRUCTIONS. INCORRECT SETTINGS WILL RESULT IN IMPROPER

PERFORMANCE, WHICH COULD RESULT IN PROPERTY DAMAGE AND SERIOUS INJURY OR DEATH TO YOU

AND/OR OTHERS.

Figure 3: Jumper plug is used to select tap settings which = dBA loudness.

Figure 4: Tap Settings (Factory setting is 70V @ 1/2W (F))

A B C D E F G H

Note: Use needle nose pliers to pull and properly insert the jumper plug to the desired tap setting.

Connect speaker wires to common and positive of terminal block and select the power tap terminal for 1/8W, 1/4W, 1/2W, 1W, 2W,

4W or 8W; 25V or 70V as required (see Figures 1, 2, 3, 4 and Table 4).

Each letter corresponds to a plug position of the header located on the printed circuit board. Select voltage and wattage as shown in

Table 4 below.

Table 4: Speaker Voltage and Wattage Connection Chart

Position 25V 70V

A 8 ------

B 4 ------

C 2 ------

D 1 8

E 1/2 4

F 1/4 2

G 1/8 1

H ------ 1/2

I ------ 1/4

J ------ 1/8

GROUNDING: Connect ground wire to backbox. Install signaling appliance to backbox using mounting screws provided.

WARNING: CHECK ELECTRICAL RATINGS SPECIFIED IN TABLE 1 AND 2 TO ENSURE PROPER

ELECTRICAL INPUT. BE SURE THAT SPEAKER WIRING IS CONNECTED TO SPEAKER TERMINALS ONLY AND

STROBE WIRING IS CONNECTED TO STROBE TERMINALS ONLY. CHECK TO INSURE THAT WIRING AT FACP

IS CORRECT. IMPROPER ELECTRICAL INPUT CAN DAMAGE THE PRODUCT OR CAUSE IT TO

MALFUNCTION.