Instruction Manual

WHEATHEART - GRAIN AUGERS 3. ASSEMBLY
X160-85, X160-105, X160-125
30875 R0 95
3.15.3. CONNECT THE POWER SWING WHEEL ASSEMBLY TO THE TUBE
1. Position the power swing underneath the swing tube. Position the power
swing axle so that the bottom clamp is on the same inclination as the swing
tube (see Figure 3.50 for clarification). Move the power swing down the
swing tube as far as possible (as close to the intake hopper as possible).
2. If necessary, wind the jack until the clamp is flush with the bottom of the
swing tube.
3. Install top clamp (electric or hydraulic) using eight 7/16” x 1-1/4” bolts and
locknuts, as shown in Figure 3.50. Tighten both sides securely.
4. Once the power swing operating position is determined, align wheels
vertically to ground. Tighten the 5/8” x 1-1/2” bolts and locknuts securely,
locking this position in place (see Figure 3.50).
Figure 3.50 Bottom and Top Clamp Positions
SWING TUBE
BOTTOM
CLAMP
RECEIVER BOX
SHEET METAL
SCREWS
TOP CLAMP