Instruction Manual

3. ASSEMBLY WHEATHEART - GRAIN AUGERS
X160-85, X160-105, X160-125
94 30875 R0
3.15.1. CONNECT THE LOWER CLAMP TO THE POWER SWING
1. Position the lower clamp assembly onto the power swing assembly. As
shown in Figure 3.48, the long side of the lower clamp must face away from
the wheels.
2. Fasten the lower clamp assembly to the power swing assembly:
a. For the front of the clamp, use two 5/8” x 1-1/2” bolts and locknuts for the
pivot point (at the front of the clamp).
b. For the rear of the clamp, insert an adjust pin to lock clamp angle and
secure it with a hairpin, as shown in Figure 3.48.
Figure 3.48 Adjustable Bottom Clamp Angle
3.15.2. CONNECT THE WHEELS ON THE POWER SWING
1. Connect both wheels to the power swing assembly using five 1/2” x 1-1/2”
wheel bolts per wheel. Tighten bolts securely.
Figure 3.49 Power Swing Wheel Assembly