Instruction Manual

WHEATHEART - GRAIN AUGERS 3. ASSEMBLY
X160-85, X160-105, X160-125
30875 R0 53
3.2.8. INSTALL THE BOOT TOW BAR
1. Insert the tow bar into the boot channel (see Figure 3.15), and secure the
back end loosely with a 3/4” x 6-1/2” bolt and 3/4” locknut through the hole in
the boot channel.
2. Tightly secure the middle of the tow bar in channel with a 3/4” x 4-1/16” x
5-3/4” U-bolt and two 3/4” locknuts.
3. Fully tighten the 3/4” nut on the 3/4” x 6-1/2” bolt.
Figure 3.15 Installing the Boot Tow Bar
Table 3.9 Install the Boot Tow Bar
Diagram # Description Part # Quantity
1 Tow bar 20694 1
2 Boot channel n/a 1
3 3/4” x 6-1/2” bolt 19593 1
4 3/4” locknut 19601 1
5 3/4” x 4-1/16” x 5-3/4” U-bolt 20684 1
6 3/4” locknuts 19601 2
1
1
2
3,4
5
6