Instruction Manual

WHEATHEART - GRAIN AUGERS 2. SAFETY
X160-85, X160-105, X160-125
30875 R0 15
2.3. OPERATION SAFETY
Have another trained person nearby who can shut down the auger in case of
accident. Always work with a second trained person around augers.
Do not operate with any of the safety guards removed.
Keep body, hair, and clothing away from moving parts. Stay away from intake
during operation.
Inspect lift cable before using auger. Replace if frayed or damaged. Make
sure it is seated properly in cable sheaves and cable clamps are secure.
Operate auger on level ground free of debris. If ground is uneven, anchor the
auger to prevent tipping or upending.
Augers are not insulated. Keep away from electrical lines. Electrocution can
occur without direct contact.
Support the discharge end and/or anchor the intake end before operating to
prevent upending.
Do not use auger as a hoist.
Empty auger before raising or lowering.
Lower auger at completion of operation or when not in use. Auger could drop
rapidly in case of cable break or hydraulic failure (where applicable).
Keep the work area clean and tidy.
Do not get on or beneath auger when raising or lowering intake hitch jack, or
when auger is supported by hitch jack.
Do not operate auger with the service or clean-out doors open or unlatched.