User Manual

3. ASSEMBLY WHEATHEART - X13 SERIES AUGERS
3.14. ATTACHING THE AUGER TUBE TO THE FRAME X1374, X1384, X1394
58 30787 R1
3.14. ATTACHING THE AUGER TUBE TO THE FRAME
Table 3.12. provides a list of parts required to attach the auger tube to the frame.
1. Ensure that the four frame attach spacers are loosely installed on the upper
and lower tube attach brackets (see Figure 3.23).
2. Arrange a strong sling around the auger tube. Attach the sling to a crane,
block and tackle, or a front end loader, and lift the auger tube high enough to
remove the stands from underneath the auger.
3. Move tube over top of the assembled frame, ensuring that the tube is
centered on the scissor frame before proceeding.
4. Connect tube to the lower frame arms:
a. Lift the lower frame arms to align with the lower frame attach spacers.
b. Grease the 1-3/4" x 19" lower frame attach pin.
c. Insert stabilizer brackets between the lower frame arm and the tube frame
attach spacers, and insert them through the lower frame arm tube
connection flange holes, stabilizer brackets, and through the frame attach
spacers.
d. Secure the lower frame attach pin with 5/16" x 2-1/2" roll pins.
Table 3.12. Parts Required, Attaching the Auger Tube to the Frame
X130-74/84 X130-94 Description Amount
29950 29950 Stabilizer brackets 2
29952 29953 Stabilizer braces 2
29995 29995 1-3/4” x 19” lower frame attach pin 2
28584 28584 5/16” x 2-1/2” roll pin 4
20079 20079 1-3/4” x 18” upper scissor frame attach pin 2
28584 28584 5/16” x 2-1/2” roll pin 2
27589 27589 5/8” x 2-1/2” bolts 1
19991 19991 5/8” x 2” bolts 1
19600 19600 5/8” locknuts 2
WARNING
Components are heavy and create a crushing
and pinching hazard if improperly handled. Be
sure to use proper hoisting equipment and
procedures, and ensure lifting apparatus is
secure before working around or under the
raised components. Failure to do so may
cause serious personal injury.