User Manual

WHEATHEART - X13 SERIES AUGERS 3. ASSEMBLY

X1374, X1384, X1394 3.10. AUGER TUBE TRUSS ASSEMBLY

30787 R1 35

3.10. AUGER TUBE TRUSS ASSEMBLY

• X130-74 augers use a double cable truss on the top of the auger tube “X130-

74 Auger Tube Truss Assembly” on page 35).

• X130-84 and X130-94 augers use a combination of rigid tube trussing on top

of the auger tube and cable trussing on the sides of the auger tube (see

“X130-84/X130-94 Auger Tube Truss Assembly” on page 40).

3.10.1. X130-74 AUGER TUBE TRUSS ASSEMBLY

INSTALL THE X130-74 CABLE BRIDGES

See Table 3.7. for a list of parts required to install the X130-74 cable bridges.

See Figure 3.12 for a detailed diagram.

1. Fasten the three truss towers to the provided brackets (welded to the

appropriate tube sections):

a. Position the high truss tower in the centre position, and position the low

truss towers toward the spout and intake ends.

b. Use two 7/16” x 1-1/4” GR8 bolts and 7/16” locknuts to fasten each cable

bridge in place.

2. Install the truss cable attach bracket as shown in the diagram, using two 

7/16” x 1-1/4” GR8 bolts and 7/16” locknuts.

Table 3.7. Parts Required, Installing X130-74 Cable Bridges

Part Number Description Amount

20017 High truss tower

18988WH Low truss towers

20105 Truss cable attach bracket

18698 7/16” x 1-1/4” GR8 bolts

17593 7/16” locknut