User Manual

WHEATHEART - X13 SERIES AUGERS 3. ASSEMBLY
X1374, X1384, X1394 3.7. INSTALL THE DISCHARGE SPOUT
30787 R1 33
3.7. INSTALL THE DISCHARGE SPOUT
1. Align the discharge spout over the opening in the upper tube.
2. Attach the discharge spout with two 7/16” x 1-1/4” GR 8 bolts [18698] and 
7/16” locknuts [17593].
Figure 3.9 Installing the Discharge Spout
3.8. SET THE THRUST ADJUSTER
1. Remove the upper bearing lock collar (if necessary).
2. Slide the lock collar and bushing onto the shaft and attach the 1-1/2” nut.
3. Turn the nut until it is snug against the bushing, then turn it so that the shaft
moves an additional 1/4” away from the top plate.
4. Secure the lock collar and tighten the set screw.
5. Install the cover over the two longer 5/8” bolts. Secure with two 
5/8” whiz-nuts.
SPOUT
7/16” X 1-1/4” BOLTS [18698]
7/16” LOCKNUTS
[17593]
Figure 3.10